Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 247

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
3 Common Administrative Procedures
Extensions
Console Display/Instructions
Specify the extension.
! 
Save your entry.
! 
Select .
Assign the extension.
! 
YYYY
l
Single Line/Trunk Procedure
Specify entry mode.
! 
Select
Enter the line or trunk number.
! 
YYYY
Ã
.
Ã
Additional Information
If no DSS is attached:
SP: "Entering an Extension"
If DSS is attached:
Toggle the red LED on or
off as required. Go to Step 5.
On = extension is assigned to
trunk or pool.
Off = extension is not assigned
to trunk or pool.
If you get the Station Busy message, wait for an
idle condition or exit system programming and try
again later.
xxxx = extension number entered in Step 3
For a single line/trunk, go to
Single Line/Trunk Procedure.
For a block of lines, go to
Block Procedure.
xxxx = extension number entered
in Step 3
Dial or type [ nnn ].
Issue 1
February 1998
Page 3-69
PC
Ã

È
Ã