Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 531

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
Lines and Trunks
Console/Display Instructions
Specify the line(s) associated with the QCC operator.
! 
Single Line Procedure
Specify entry mode.
! 
Select
Enter the line/trunk assigned to ring into the QCC queue.
! 
Assign or remove the line/trunk from the specified QCC operator.
! 
Select or
Continue to assign line/trunk to another QCC operator or go to Step 5.
! 
Select .
YYYY
.
YYYY
.
Additional Information
xxxx = extension number entered in Step 4
For a single line/trunk, go to
Single Line Procedure.
For a block of lines/trunks, go to
Block Procedure.
xxxx = extension number entered in
Step 4
Dial or type:
Trunk number [ nnn ]
Slot and port number
Logical ID number
You may continue to assign or remove additional
lines/trunks from the QCC operator by repeating
Steps 2 and 3.
Return to Step 2. The next QCC operator
is displayed on Line 1.
February 1998
Page 4-61
[ sspp ]
[ nnn ]
#
Issue 1
PC
È
Ã