Programming Needed After Upgrade To Release 5.0 - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
2 Programming with SPM
Upgrading the System
Table 2–13. Continued
Feature
PRI Call-by-Call
Services Table
Table 2–14. Programming Needed after Upgrade to Release 5.0
Feature
CTI Link
Sequence
To select MCI Toll Call-by-Call Services for a
DMS-250 or DEX600E switch type:
no.
To specify local exchange carrier Dial Plan Routing
services for a DMS-100 switch type:
no.
or
Sequence
This is a Maintenance step. Start the procedure from
the main menu, not the System Programming screen.
Busy out the board first:
Menu
Program the CTI Link (the switch must be in
Hybrid/PBX mode):
This is a Maintenance step. Start the procedure from
the main menu, not the System Programming screen.
Restore the slot:
Menu
NOTE: NOTE: NOTE:
If the MLX module containing the CTI Link is the first module,
use the SPM program to busy-out the slot.
Dial slot no.
Dial extension no.
Dial slot no.
.
Continued on next page
Issue 1
February 1998
Page 2-74
List
or
List
or