Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 119

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
2 Programming with SPM
Accessing SPM
The password prompt appears on the screen when the connection is
made. (You may have to press
prompt.)
If the PC is in a remote location and your system has not activated the
Remote Access feature, do the following:
NOTE: NOTE: NOTE:
If you enter a telephone number of fewer than 11 digits, you must end it with
a pound sign (#).
To access SPM through a local or remote modem connection, follow the steps
below.
Set up the appropriate physical connections between the PC and the control
! 
unit. See "Connecting the PC" on page 13.
Type „x and press
! 
If you wish to program in a language other than the current language set for SPM, see
"Set the Programming Language" on page
Press any key to display a blank screen on which you can enter modem
! 
commands. (You may have to press the key several times.)
Make a data connection to the modem of the control unit.
! 
See "Modem Connections" on page 18.
prompt appears as shown in Step 4.
— Use the main telephone number to place a voice call to the system
on the line to which the modem is connected.
— Instruct the operator to transfer you to the modem (by pressing
Transfer, dialing   , then hanging up the telephone).
— To put the modem on line, type 6UC and press
up the telephone.
to display the SPM Welcome screen shown below.
;;;
more than once to get the password
X.XX = current version of SPM
2–18.
When the connection is made, the password
Issue 1
February 1998
Page 2-19
, then hang