Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 153

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
2 Programming with SPM
System Programming
Identify telephones with voice signal pairs for the Voice Announce to Busy
feature
Identify telephones that need the Simultaneous Voice and Data feature
Restore system programming information
Identify the Music On Hold jack
When the system is forced idle, the following occurs: multiline telephone users
hear a reminder tone that indicates the telephone cannot be used; display
telephone users see the message Xhv‡)ÃT’†‡r€Ã7ˆ†’ ; single-line telephone
users do not hear a dial tone.
Line or Trunk Idle
Since these procedures require the line or trunk to be idle only at the instant of
programming, the line or trunk is not forced idle. The following procedures can be
performed only when the line or trunk being programmed is idle:
Identify loudspeaker paging line jack
Assign trunks to pools
Specify incoming or outgoing DID- or tie-trunk type
Specify tie-trunk direction
Specify tie-trunk E&M signal
Extension Forced Idle
When an extension is forced idle, no calls can be made or received on that
extension. The following procedures can be performed only when the extension
being programmed is idle:
Assign call restrictions
Assign pool dial-out restrictions
Copy extension assignments
Assign lines, trunks, or pools to extensions
Assign labels to a personal directory
Use centralized telephone programming
When the extension is forced idle, the following occurs: multiline telephone users
hear a reminder tone that indicates the telephone cannot be used; display
telephone users see the message Xhv‡)ÃT’†‡r€Ã7ˆ†’ ; single-line telephone
users do not hear a dial tone.
2
2
Issue 1
February 1998
Page 2-53