Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 194

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
3 Common Administrative Procedures
System Renumbering
Console Display/Instructions
Enter the new extension.
! 
YYYY
Ã
Save your entry.
! 
Ã
(QWHU
Select
.
Return to the System Programming menu.
! 
Select two times.
Block Renumbering
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are being
changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
! !
CAUTION: CAUTION:
Select (YJU on the console or
renumbering extensions. If you press Home, extensions may remain in the
forced idle condition (indicated when the LED next to each DSS button is
on). To restore extensions to their normal operating state, restart the
system.
Summary: Block Renumbering
Programmable by
Mode
Idle Condition
or
System Manager
All
System idle
Additional Information
**** = item selected in Step 4
xxxx = extension entered in Step 5
SP: "Entering an Extension"
If you use to renumber the next item (
displayed on Line 1, return to Step 7.
3
Ç
on the PC when you have finished
3
Issue 1
February 1998
Page 3-16
PC
Ã


)
ÇÇ