Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 528

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
Lines and Trunks
Block Procedure
Console Display/Instructions
Specify the block of 20 lines associated with the 20 line buttons on the system
! 
programming console.
Select
Assign the queue priority specified.
! 
Return to the System Programming menu.
! 
Select twice.
QCC Operator to Receive Calls
Use this procedure to specify whether or not incoming calls on each line/trunk ring
into the QCC queue and to identify the QCC system operator positions that
receive incoming calls on each line/trunk.
NOTES:
1. This procedure applies to Hybrid/PBX mode only in a system that
2. Each ground-start, loop-start, or automatic-in tie trunk programmed to
3. If a trunk assigned to ring into the QCC queue is also used for shared
4. Do not change the factory setting of No QCC Operator Assigned to
includes QCC operator positions.
ring into the QCC queue can be associated with one or more QCC
operator positions.
remote access, see See
must assign remote access before you assign a QCC system operator
to receive calls (see
–294).
Receive Calls for trunks dedicated to incoming calls for calling groups,
trunks used as personal lines, DID trunks, unequipped DS1 trunks, or
dial-in tie trunks.
Additional Information
Toggle the green LED on or off as required.
On = to assign the queue priority
Off = not to assign the queue priority
4
"Remote Access Features" on page 337.
"QCC Operator to Receive Call Types" on page
Issue 1
February 1998
Page 4-58
PC
à Ä
Å Æ
ÇÇ
You