Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 105

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
2 Programming with SPM
Installing the SPM Software
Creates the following directories if they do not already exist:
Does one of the following:
Follow the steps below to install SPM on the PC's hard disk.
Switch to Drive A, if it is not already the current drive.
! 
appears on the screen.
Insert the backup copy of the SPM diskette into Drive A.
! 
Type one of the commands shown below and press
! 
install
install french
install spanish
Because English is the default language,
same result. If you do use the language argument (
must type it in lowercase letters as shown. The command
or lowercase.
Wait for the message shown below to appear.
! 
Press any key to begin the installation.
! 
When the installation is finished, the following message appears:
Remove the SPM diskette from Drive A and reboot your system.
! 
The installation procedure is complete.
Go to "Initializing the SPM Software" on page 2–9
— c:\spm\backup
— c:\spm\reports
— c:\spm\tmp
— Creates the SPM configuration file c:\spm\ams.cfg, if it does not
already exist. In this case, the ams.cfg file consists of only one line,
in which the language attribute is specified:
English or did not specify a language with the
— Modifies the ams.cfg file, if it already exists, by adding or changing
the LANG value.
if you specified
.
and
, , or
may be uppercase
.
Issue 1
February 1998
Page 2-5
command;
have the
, you
)