Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 461

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
3 Common Administrative Procedures
Memory Card
NOTE: NOTE: NOTE:
If the system performs a System Erase (frigid start), all programming is set
to the default values. If a previous backup file is available, perform a
restore. If not, the system must be reprogrammed. See
–447
Messages" on page –290
the backup procedure.
Summary: Backup
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure Insert memory card
PC Procedure
Procedure: Backup
Console Display/Instructions
Insert the memory card into the PCMCIA interface slot on the
! 
processor module.
for information about the system restore procedure. Also see
for information about errors that may occur during
System Manager
All
Not required (No extensions are allowed to be in
programming mode except system programming console)
Form 1, System Planning
Not applicable
1- to 11-character filename
Yes
No
7hpxˆƒ
Select backup file
@‡r…
filename
Insert memory card
Ç Ç Ç
file Type the new backup filename
Additional Information
3
T’†‡r€ 7hpxSr†‡‚…r
Dial the new backup
à  Ã
`r† @‘v‡
3
See Figure 3–5, "Inserting the Memory Card."
February 1998
Page 3-283
"Restore" on page
"Backup
@‘v‡ @‘v‡
È Ã
Select backup
Issue 1
PC