Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 45

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
1 Programming Basics
Programming Procedures
Using Next
When you are programming a feature that can apply to a sequence of extensions,
lines/trunks, or groups, the screen key
( on the PC) permits you to save your current entry and display the next
number in the sequence. You can continue to press
programming the entire sequence. When the last number in the sequence
displays on the screen, press
entry and move to the next step of the procedure. Procedures that allow the use of
direct you to the correct screen to continue programming as shown in Step 6
in the example below.
NOTE: NOTE: NOTE:
If you plan to take advantage of this key, remember to enter the lowest
number in the sequence at the first prompt.
Specify whether the operator receives the alert.
! 
R88ÃPƒr…h‡‚…ÃYYYY
Save your entry.
! 
Select
Return to the System Programming menu.
! 
Select twice.
or
1
appears on the console display.
( or on the PC) to save the final
xxxx = operator entered in Step 1
Select
Use to program the next QCC position. Go
to Step 5.The next QCC operator will be
displayed on Line 1. After programming the last
QCC operator position, select enter and go to
Step 7.
Issue 1
February 1998
Page 1-23
until you finish
or
.
Ã
Ä