Programming Basics - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
1

Programming Basics

Programming Procedures
The first branch procedure from sample Step 3 is shown below.
l
AT&T Toll Procedure
Console/Display Instructions
Specify a service.
! 
Save your entry.
! 
Select .
Repeat Steps 1 and 2 of the main procedure for each toll group number.
! 
For additional toll services, go to Step 1; then continue with Step 5.
! 
Return to Step 4 of the main procedure.
! 
Each branch procedure is self-contained and begins with Step 1. Be sure to
complete all of the steps in a branch procedure before you return to the main
procedure.
The examples in the following text refer to Steps 1 through 5 of the
Procedure (above), which is a branch of the Network Services procedure.
When you are to repeat a step within the branch procedure, you are instructed to
go to that step. For example, at Step 4 of the branch procedure you would go
back to Step 1 of the branch procedure and repeat branch Steps 1 through 4 for
additional toll services. If you did not need to enter any other toll services, you
would continue with Step 5 of the branch procedure.
When a branch step instructs you to return to the main procedure, the branch
procedure is complete. At Step 5 of the branch procedure you would return to
Step 4 of the Network Services procedure to continue. In some cases, you can
select
are noted in specific programming procedures. In cases where completing the
Ç
branch procedure also completes the main procedure you are instructed to select
(
menu.
YY
Ç
( on the PC) to return to the menu where the branch begins; these
on the PC) one or more times to return to the system programming
Additional Information
xx = number entered in Step 5
Press the button or function key next to
your selection.
Issue 1
February 1998
Page 1-18
PC
Ã

l
AT&T Toll