Installing Spm; Accessing Spm - Lucent Technologies MERLIN LEGEND Release 6.0 Pocket Reference

DEFINITY ECS Release 6
System Description Pocket Reference 555-230-211
Technical Addendum

Installing SPM

Follow these steps to install System Programming and
Maintenance (SPM) onto the hard drive of a computer:
1. Insert the SPM diskette into the computer.
2. At the C: prompt, type MKDIR SPM and press ENTER.
3. Type cd\spm and press ENTER.
4. Type a:install and press ENTER to install the program from the
diskette.
5. After the installation is complete, type spm and press ENTER to
display the SPM Welcome screen.

Accessing SPM

Direct Local Connection
Follow these steps to access SPM when you are directly connected
to the system via the administration jack on the processor module:
1. Set up the physical connection between your laptop or PC and
the control unit.
2. Type spm and press ENTER to display the SPM Welcome
screen.
3. Press any key to display the SPM Main Menu.
Local Modem Connection
Follow these steps to access SPM when you are connected on-site
via a modem:
1. Set up the physical connections between the PC and a 012
module on the control unit.
2. Type spm and press ENTER to display the SPM Welcome
screen.
3. Press ENTER to display a blank screen on which you can enter
modem commands. (You may have to press ENTER several
times.)
4. Dial
5. Type the SPM password to display the SPM Main Menu.
Technical Addendum
Issue 2
January 1998
Page 145