Accessing Spm - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM

Accessing SPM

NOTE: NOTE: NOTE:
Remote access (modem connection) has priority over local access (direct
connection), unless a backup or restore procedure is in progress through a
direct local connection. If a modem connection is attempted while any other
type of on-site programming is in progress (either at the system or at a
directly-connected PC), the system sends a message to the on-site
programmer. The message indicates that a modem connection is being
established and the on-site programming session is terminated.
Accessing SPM
The procedure for accessing SPM depends on whether your PC is connected to
the control unit with a modem (either local or remote) or without a modem (direct).
This section covers both of these access procedures.
With a Direct Local Connection
To access SPM when your PC is connected directly to the control unit, follow the
steps below.
Set up the appropriate physical connections between the PC and the control

unit.
See ''Connecting the
If you installed SPM on the hard disk of the PC, go to Step 5.

If the PC does not have a hard disk, insert the SPM diskette into Drive A.

Type and press
a:

A:>
Type spm and press

Welcome to SPM
The MERLIN LEGEND
System Programming
& Maintenance Utility
Please press any key
to continue
Version X.XX
PC''.
.
appears on the screen.
to display the SPM Welcome screen shown below.
2
2
X.XX current version of SPM
Issue 1
June 1997
Page 2-15