Automatic Route Selection - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Common Administrative Procedures

Automatic Route Selection

Automatic Route Selection
This section contains programming procedures for the following Automatic Route
Selection (ARS) features:
1 + 7-Digit Dialing Requirements
ARS Tables
Start and Stop Times for Subpatterns
Pool Routing
Facility Restriction Level (FRL)
Digit Absorption
Other Digits
N11 Special Numbers Tables
Dial 0 Table
Voice and/or Data Routing
NOTE: NOTE: NOTE:
ARS applies to Hybrid/PBX mode only.
ARS over Networked Tandem PRI
and Tie Trunks
In Release 6.0 and later systems, Hybrid/PBX mode only, callers on one system
can use lines on another system speedily and transparently when optimal cost
efficiency dictates the need for lines connected to a different switch in the
organization's private network (in prior systems, it is necessary to make an explicit
remote-access call, enter a barrier code, and finally use ARS). To permit this
operation, both the local and remote systems must be programmed using ARS
and remote access options.
Remote Users Calling out on Local
Networked Lines
To implement this operation on a local system where remote callers will use the
networked lines connected to your system, use the procedures outlined in the
section "Remote Access Features" on page
4
4
4
–337.
Issue 1
February 1998
Page 4-363