Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 209

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
3 Common Administrative Procedures
System Operator Positions
Console Display/Instructions
Select Direct-Line Console (DLC).
! 
Specify the DLC extension as a DLC position.
! 
T‡‚…rÃ6yy
7hpx†ƒhpr
@‘v‡
Assign or remove the DLC operator extension.
! 
Select @‡r… or
9ryr‡r .
Indicate that you have finished entering all positions.
! 
Select T‡‚…rÃ6yy .
Additional Information
9ryr‡r
@‡r…
If you get the System Busy message, wait
for an idle condition or exit system
programming and try again later.
If no DSS is attached:
SP: "Entering an Extension"
If DSS is attached:
Toggle the red LED on or
off as required. Go to Step 6.
On = extension is currently assigned
Flashing = extension can be assigned as a
DLC position.
Off = extension cannot be assigned as a
DLC position.
You may continue to assign or remove
DLC operator positions by repeating Steps
4 and 5.
The session is terminated, and the system
restarts. You must enter system
programming again to continue.
Issue 1
February 1998
Page 3-31
PC
Ã
Ã


Å