Initializing And Testing The System; Initializing The System - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0 MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140 Installation

Initializing and Testing the System

Initializing the System

Initializing and Testing the System
7
When you have finished installation, you are ready to initialize the system as
described in this chapter.
Initializing the System
To initialize a Release 5.0 system, use one of the following methods:
Restore from a 5.0 system programming disk or Translation memory
card.
Upgrade to Release 5.0 from Release 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 4.0, 4.1,
4.2, or 5.0. See
Use system programming forms and the procedures from one of the
guides listed in the next section, "Programming Guides."
This section describes how to restore the system from the Translation memory
card or the system programming disk.
NOTE:
On initial installations, make sure you perform a System Erase (frigid
start), as described in Maintenance and Troubleshooting, either
immediately before you restore from a disk or memory card or before you
program the system. Failure to perform the System Erase (frigid start) can
result in incorrect programming.
Chapter 9, ''Upgrading the System''.
Issue 1 Issue 1
June 1997 June 1997
Page 7-1
7