Installing The Processor In The Carrier - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Installing the Control Unit
Installing the Processor
!
CAUTION:
Before touching leads, connectors, pins, and other components when
handling the circuit board, use a properly grounded wrist strap to prevent
damage from electrostatic discharge (ESD).

Installing the Processor in the Carrier

To install the processor in the carrier, follow the steps below. Refer to
2-10.
Remove the protective cover from the gold-finger connector on the

back of the processor.
Lower the hook on top of the processor module onto the rod on top

of the carrier in Slot 0, the first slot next to the power supply.
Make sure that the connector on the module mates properly with

the connector on the carrier as you swing the processor down into
place.
!
CAUTION:
To avoid damage, do not force the module. If the module does not insert
easily, press the bottom rear locking tab, remove the module, and inspect
the module and carrier for damage or obstruction. The bottom-rear locking
tab is shown in
If there is no damage and no obstruction, reinsert the module.
A damaged carrier or module must be replaced.
Push firmly until the processor snaps into place.

The processor should be securely attached to the carrier and locked in
place by the locking tab on the bottom rear of the processor.
Figure 2-10. This tab is used on all modules.
Issue 1
June 1997
Page 2-31
Figure