Setting The Time And Date; Testing The System; Testing Mlx Telephones - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Initializing and Testing the System

Setting the Time and Date

Use SPM and the system programming disk to perform the Restore

procedure.
See System Programming and Maintenance (SPM) for instructions.
NOTE:
You must restore the system using either the system programming (or
backup) disk or memory card whenever a frigid start (System Erase)
occurs.
Setting the Time and Date
If the Control Unit Diagram indicates that you should set the time and date, do
so before you test the system.
Follow this procedure:
Menu
SysProg
See System Programming if you need additional instructions.

Testing the System

Once you have initialized the system, it is ready for system acceptance testing.
Perform the basic tests below to test trunks, telephones, and features.
If any equipment is not working properly, see Maintenance and Troubleshooting
for troubleshooting instructions.

Testing MLX Telephones

This switch-based software test verifies that the LEDs, ringer, buttons,
switchhook, and B-channel operation for MLX telephones are working correctly.
You cannot run this test when the telephone is in programming, forced-idle, or
maintenance mode. When an MLX telephone is in test mode, the system
considers it busy and therefore not available for use.
System Date Drop
Dial current date
Issue 1
June 1997
Page 7-3
Enter