Installing The Control Unit's Housing; Installing The Top Cover - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Initializing and Testing the System

Installing the Control Unit's Housing

Dial
123456789*0# .

You should hear a dual-tone multifrequency (DTMF) signal as each
button is pressed. When you finish dialing, you should hear a 3-beep
confirmation tone.
Repeat the test for each TTR.

Installing the Control Unit's
Housing
After you complete system acceptance testing and if you are confident that the
system is completely installed, you can install the control unit's housing.
NOTE:
Beginning with Release 2.1 or later, the control unit covers are identical to
those on the MERLIN II Communications System. If you need to install
control unit covers on a system prior to Release 2.1, see
''Upgrading the

Installing the Top Cover

To install the top cover, see
Be sure the cords have been pressed through the wire managers at

the base of the modules.
Hold the top cover with the hooks facing you.

Engage the tabs at the rear of the top cover with the carrier.

Lower the top cover so the legs lock into the vents on the module.

System''.
Figure 7-2 and follow these steps:
Issue 1
June 1997
Page 7-20
Chapter 9,