Removing The Control Unit Housing - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Upgrading the System

Removing the Control Unit Housing

Removing the Control Unit Housing
Remove the control unit housing as described below. See
For a MERLIN II or a MERLIN LEGEND (Release 2.1 or later)
Communications System:
1. Remove the front housing from each carrier by pulling the bottom
2. Remove the top from each carrier in the system by pushing it
3. Do not discard the housing unless new housing is provided. You
For a MERLIN LEGEND (Release 2.0 or earlier) Communications
System:
1. From both sides of the control unit, pry the clips free from the
2. Carefully pull the housing towards you.
3. If the system has more than one carrier, make sure you remove
4. If the housing clips need to be replaced, follow the procedure in
5. Discard the housing only if upgraded housing has been provided.
front towards you, and lifting it up as shown in
straight up from the front.
will reassemble the housing when installation is complete.
housing, using a screwdriver if they are difficult to reach.
the housing only from the basic carrier side; otherwise, the
housing may disassemble.
"Replacing the Housing Clips."
Issue 1
June 1997
Page 9-6
Figure 9-1.
Figure 9-1.