Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual page 239

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Initializing and Testing the System
Testing the System
At the ringing telephone, have someone pick up the handset and

verify that you have good two-way communication.
Repeat Steps 2 and 3 for each calling group.

Make additional calls to check each member of each calling group.

At any telephone, pick up the handset and dial the group extension

number.
Test the calling group delay announcement (if provided) for each

group.
a. Make the group busy or have all members log out of the group (by
b. Repeat Step 2.
c. After listening to the delay announcement, hang up.
d. Repeat these steps for each group.
At the ringing telephone, have someone pick up the handset and

verify that you have good two-way communication.
System Speed Dial Test
To test System Speed Dial numbers, follow the steps below:
Find out which numbers have been programmed for System Speed

Dial.
See the system manager or use Form 10b as a reference for System
Speed Dial numbers.
From the test telephone, pick up the handset and dial a System

Speed Dial code.
Verify that you have good two-way communication and that the correct
party was reached.
Coverage Test
To verify that coverage is in effect, follow the steps below:
Have someone call the covered telephone.

Count the number of rings at the covered telephone before the

covering telephone starts ringing.
This should be the same as the programmed number of rings.
dialing at each group extension).
#*44
Issue 1
June 1997
Page 7-14