Assembling Mlx Telephones; Considerations - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Installing Telephones and Adjuncts

Assembling MLX Telephones

Assembling MLX Telephones
You will need to assemble an MLX telephone before connecting it to the control
unit. For all other telephones, skip to "Connecting Telephones to the Control
Unit."

Considerations

Review the following items before you begin the procedure:
MLX telephones are packed with the deskstand in the low position. You
can use the deskstand as is, raise it to a higher angle, or remove it. To
adjust or remove the stand, see Step 1 of the following instructions. (The
diagram on the bottom of the user card tray also shows how to adjust the
stand.)
You cannot wall-mount MLX-20L and MLX-28D telephones.
If you wish to wall-mount an MLX-5, MLX-5D, MLX-10, MLX-10D,
MLX-10DP, or MLX-16 DP telephone, you must remove the deskstand
first. (Wall-mounting an MLX-5D,MLX-10D,MLX-10DP, or MLX-16DP
telephone can make the display hard to read.)
A 630B Phonemount (not included) is also required to mount an MLX-10,
MLX-10D, or MLX-10DP telephone on the wall.
To connect an adjunct (such as an alert, modem, or fax machine) to an
MLX telephone, the telephone must have an MFM installed in it. If you
have not already done so, refer to
earlier in this chapter.
''Installing Multi-Function
Issue 1
June 1997
Page 3-48
Modules'',