Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual page 68

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Installing the Control Unit
Installing the Basic Carrier
To install the basic carrier, follow the steps below:
Mark the screw-hole locations on the backboard, using the basic

carrier or the template supplied with the plastic preassembled
backboard as a guide. See
Make sure the carrier is level before marking the holes.
Drill a pilot hole in the center of each of the four screw-hole marks.

Anchor the screws approximately halfway into the backboard.

Position the carrier on the screws and slide the carrier to the left.

Tighten the screws.

Figure 2-5. Marking the Basic Carrier Screw Holes
Mounting Surface
Mounting
Screw
Figure 2-5.
Backboard
Basic
Carrier
Issue 1
June 1997
Page 2-19