Setting Printer Options And Dip Switches - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Installing the PC, CAT, or Printer
Connecting a Printer to the Control Unit
On the printer side, plug one end of a D8W cord into the wall jack

and the other end into the WALL jack on the Z3A2 ADU.
Plug one end of an EIA-232-D cable into the 25-pin male connector

on the Z3A2 ADU and the other end into the serial port on the
printer.
Plug the 2012D-50M (or 2012D) transformer into a wall outlet.

Set the appropriate printer options for SMDR.

See

''Setting Printer Options and DIP Switches''

Setting Printer Options and DIP Switches
If the customer has an Lucent Technologies 572, Lucent Technologies 475/476,
CAT, or Lucent Technologies Applications printer, use this section to set up
printer options. If another type of serial printer is being used, review these setup
options for guidance and consult the manual for the printer. Use the information
below to determine the correct printer setting for the printer:
For the 572 printer, set the options on the printer according to
(See the user's guide supplied with the printer for more information.)
For the 475/476 printer, set the DIP switches on the printer according to
Table 5-2. (See the user's guide supplied with the printer for more
information.)
For the CAT printer, set the DIP switches on the printer according to
Table 5-3. (See the user's guide supplied with the printer for more
information.)
For the Applications printer, set all the DIP switches on the printer to off.
(See the user's guide supplied with the printer for more information.)
If the 400B2 is plugged into a wall jack, make sure that building
wiring has been set up so that the wall jack for the control unit can
communicate with the wall jack for the printer.
If the 400B2 is plugged into a BR1A-4P adapter, 102 connecting
block, or 103 connecting block, use 4-pair plug-ended cable to
connect the BR1A-4P adapter (or connecting block) to the wall
jack for the printer.
Issue 1
June 1997
Page 5-21
for instructions.
Table 5-1.