Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual page 166

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Connecting the Control Unit to the Network Interface
Wiring
Spudger
Figure 4-3. RJ21X Wiring Field Tools
To connect the RJ21X network interface to the control unit, follow the steps
below. Figure 4-3
For each piece of hardware, drill two diagonally opposite holes into

the backboard, allowing for a 1/16-inch (1.6 mm) space between
each piece of hardware.
Mount the wire troughs and the termination blocks.

There is a wire trough above and below each termination block.
AT-8762 D
Impact Tool
110 Impact Tool
788J1
shows the tools you need.
788 K1 Retainer
Tool
Modular Plug Pressers
Issue 1
June 1997
Page 4-7