Mlx-5 And Mlx-5D Telephones - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
New Features and Enhancements
Release 5.0 Enhancements
If all three thresholds are set to the same value, the result is one threshold only
(steady) with LED state either off or on. If two values are the same, then the
result is two alarm levels (flash, steady). The factory setting is one call for all
three thresholds with LED states of off, flash, and steady.
An external alert only signals when the number of calls in the queue exceeds
the programmed Threshold 3 value.

MLX-5 and MLX-5D Telephones

The MLX-5 nondisplay and the MLX-5D display telephones are compatible with
all system releases. The display telephone includes a 2-line by 24-character
display, and both telephones come with 5 line buttons. In systems prior to
Release 5.0, the MLX-5 and MLX-5D telephones are treated as MLX-10 and
MLX-10D telephones respectively. As of Release 5.0, the system recognizes
the MLx-5 and MLX-5D telephones as 5-button telephones.
If these telephones are connected to communications system releases prior to
5.0, they are recognized by the communications system as 10 button
telephones.
NOTE:
A DSS (Direct Station Selector) button that is used as a
Calls-in-Queue Alarm button can only indicate two
threshold levels, either by flashing or by lighting steadily. If
a calling group must use this type of Calls-in-Queue Alarm
button, only two threshold levels should be programmed.
0
Issue 1
June 1997
Page xxix