System Forms - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Introduction

System Forms

5. Connect the control unit to the network interface (required).
6. Connect the channel service unit (CSU) to the 100D module on the
control unit (required only with the 100D module).
7. Connect the printer and PC to the control unit (optional).
8. Connect data equipment to the control unit (optional).
9. Initialize and test the system (required).
10. Install the control unit housing (required).
11. Install applications (optional).
A list of required tools and equipment is given before each installation
procedure.
System Forms
Some of the installation procedures in this guide refer to system forms. These
forms indicate information that is specific to your customer's system. The forms
you need should be included with the system programming disk or memory
card, which contains all of the programming specifically for your customer's
system.
If you are upgrading an existing system and do not have the required forms for
your customer's system, you can load System Programming and Maintenance
(SPM) and print out the required forms.
If you find that you do not have a completed set of system forms for your
customer's system, contact your technical support organization or the Customer
Service Center (CSC). See the inside front cover for telephone numbers.
The system forms that you need are specific for each system, and include some
or all of those described in the following sections.
Issue 1
June 1997
Page 1-2