Upgrading The System; Upgrading To Release 5.0 - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0 MERLIN LEGEND Communications System Release 5.0
Installation Installation 555-650-140

Upgrading the System

Upgrading to Release 5.0

Upgrading the System
9
!
!
WARNING:
System upgrades should be performed by qualified technicians or
service personnel only. Installation or maintenance of this product
by anyone other than qualified personnel may damage or impair
the product; your limited warranty does not cover such damage.
For details, see your limited warranty in Appendix A, Customer
Support Information, in Maintenance and Troubleshooting or
System Programming .
NOTE:
Upgrading the MERLIN LEGEND Communications System to Releases
4.1, 4.2, and 5.0 requires no new or additional hardware components.
Releases 4.1 and 4.2 improve feature capability and Release 5.0 adds the
flexibility of a CTI link. The sections below indicate what is necessary for
the upgrade. To perfrom the actual upgrade, refer to System
Programming for detailed procedures.
Upgrading to Release 5.0
You must have DOS SPM Version 5.15 to upgrade to Release 5.0 from
Releases 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, or 4.0.
To upgrade to Release 5.0, you need:
SPM Version 5.15 or later to back up and convert system programming
information and to restore system programming information after the
Release 4.0 processor module has been installed.
Issue 1 Issue 1
June 1997 June 1997
Page 9-1
9