MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Upgrading the System
Replacing the Control Unit Housing
Replacing the Control Unit Housing
See
Chapter 2, ''Installing the Control
control unit housing for Release 2.1 and later.
Release 2.0 or Earlier
To install the control unit housing, follow the steps below.
Place the front panel(s) face down.
If you are housing more than one carrier, connect the front panels
together.
a. Line up the arrows.
b. Slide the panels until the semicircles form a complete circle. See
Connect the side panels to the front panel(s) in the same way.
Pick up the housing and place it on the control unit. If the system
has more than one carrier, make sure you hold the housing only
from the basic carrier side; otherwise, the housing can
disassemble.
a. Line up the wire clips that are attached to the carrier with the
b. Push back the panels until the clips hook over the tabs and rest in
Figure
9-8.
recesses on the outside of the side panels.
the recesses.
Unit'', for instructions on replacing the
Issue 1
June 1997
Page 9-21
Need help?
Do you have a question about the MERLIN LEGEND Release 5.0 and is the answer not in the manual?