Modem Data Stations - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Connecting Data Equipment
Data Stations
NOTE:
The analog voice and modem data station requires a bridging adapter to
connect the telephone to the two adjacent analog extension jacks.
The terminal adapter data-only station requires a terminating resistor
adapter to connect the terminal adapter to the MLX extension jack.
See ''Video Conferencing Data
configuration details on stations including video codecs.
The cord length from the terminal adapter to the telephone cannot be
more than 80 ft. (24 m).
Do not connect two terminal adapters on one line.

Modem Data Stations

A modem data station uses a modem to convert digital signals so that it can
send and receive analog signals. This type of station allows data
communication without PRI facilities.
The system supports the types of modem data stations listed below.
Analog Voice and Modem Data. This station includes a data terminal
and an analog multiline telephone.
Modem Data-Only. This station includes a data terminal and modem. If
this station's modem has a phone jack, you can connect a single-line
telephone; however, voice and data at the same time are not possible.
MLX Voice and Modem Data. This station includes a data terminal, a
modem, and an MLX telephone.
See Form 2a, System Numbering: Extension Jacks for your customer's
specifications. Then refer to the appropriate section later in this chapter for
instructions on setting up modem data stations.
Stations'', later in this chapter, for
Issue 1
June 1997
Page 6-3