Testing Bri Trunks; Testing Selected System Features - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Initializing and Testing the System
Testing the System
Pick up the handset. (In Hybrid/PBX systems with pooled tie trunks,

press an SA button and dial the pool dial-out code.)
The green LED next to the selected button lights.
Dial the tie-trunk number of the extension where someone is

waiting for your call.
You should hear ringing.
When the person answers, verify that you have good two-way

communication, then hang up.
The green LED should turn off, the red LED should turn off, and another
red LED may turn on.
Repeat Steps 1 through 4 for each outgoing or two-way

dial-repeating tie trunk.

Testing BRI Trunks

Perform the testing described in " 800 NI-BRI Module Problems" in Chapter 4 of
Maintenance and Troubleshooting .

Testing Selected System Features

This section provides procedures to test the following system features:
Automatic Route Selection (ARS). For Hybrid/PBX mode only. Use the
same test for Idle Line Preference, a similar feature used in Key mode
only. Use the same test for Station Message Detail Recording (SMDR),
as explained in the test procedure. Refer to Planning Forms 3e, 3f, and
3g for ARS information.
Group Calling. Use the same test for the Listed Directory Number (the
QCC queue), which is for Hybrid/PBX only. Use the same test for Group
Paging. Refer to Planning Form 7d for Group Calling information.
Coverage. Refer to Planning Form 7c for Group Coverage information.
Issue 1
June 1997
Page 7-12