Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual page 263

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Installing Applications
Integrated Solution III
The Master Controller III is a tower 20-MHz 486-SX PC with six available EISA
bus slots (with the tape drive installed). It has 8 MB of RAM memory, either 200-
or 500-MB hard disk drive, and a 250-MB streaming tape drive.
The following hardware is also required:
A 355AF adapter for connecting the Master Controller to the serial port
on the control unit if they are within 50 ft. (15.2 m) of each other and are
on the same AC branch circuit
ADUs for connecting the Master Controller to the serial port on the
control unit, if they are not within 50 ft. (15.2 m) of each other and/or they
are not on the same AC branch circuit
Any additional hardware required by the individual applications included
in IS III, including the cables and adapters for connecting the applications
to the system
IVP4 boards or IVP6 cards for AUDIX Voice Power and FAX Attendant
012 or 016 basic telephone module to provide the tip/ring interface for
AUDIX Voice Power
TR114 boards for FAX Attendant
A summary of the installation procedure is provided below:
Set up the equipment and identify the hardware for IS III.

Connect the hardware as shown in the instructions.

Install the software and test the IS III application.

If a voice application is installed, you will need two 125-MB tape
cartridges for system backup.
For more information, consult Integrated Solution III Installation and
Maintenance Guide.
Issue 1
June 1997
Page 8-16