Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual page 168

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Connecting the Control Unit to the Network Interface
Wiring
Test the central office trunks for proper connection.

See ''Testing
Label the network interface jacks, control unit module jacks,

termination blocks, and D2R cords.
See ''Labeling
For each trunk, plug one end of a D2R cord into the designated jack

on the termination block and the other end into the line/trunk jack
on the proper control unit module.
NOTE:
The modular jacks on the termination block are 8-wire jacks. The D2R
cords, which are 6-wire, also plug into the 8-wire jacks.
!
CAUTION:
Do not plug an analog multiline telephone, an MLX telephone, or
anything else that should be plugged into an extension jack into this
wiring field: doing so will busy-out the trunk.
Trunks'', later in this chapter, for instructions.
Trunks'', later in this chapter, for instructions.
Issue 1
June 1997
Page 4-9