Control Unit Requirements; Hardware Preassembly Process - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Installing the Control Unit
Overview

Control Unit Requirements

Dimensions
— Basic carrier: 14 in. wide by 23 in. high by 12 in. deep
— Basic carrier and one expansion carrier: 25 in. wide by 23 in. high
— Basic carrier and two expansion carriers: 37 in. wide by 23 in. high
Location
— Within 5 ft. (152 cm) of an AC power outlet that is not
— Within 25 ft. (762 cm) of the network interface, or use an
— Within 1000 cable ft. (305 m) of telephones, or use an OPRE (for
!
CAUTION:
The AC outlet for the control unit cannot be switch-controlled.
Plugging the control unit into such an outlet invites accidental
disconnection of the system.

Hardware Preassembly Process

If an installation is to be preassembled, wired, programmed, and tested on the
new lightweight plastic backboard, see
by 12 in. deep
by 12 in. deep
switch-controlled
Off-Premises Range Extender (OPRE)
basic telephones)
''Installing the Backboard''.
Issue 1
June 1997
Page 2-4