Link Reinstatement - Lucent Technologies MERLIN LEGEND Release 5.0 Installation Manual

MERLIN LEGEND Communications System Release 5.0
Installation 555-650-140
Installing Applications
Installing a CTI Link
Refer to the MERLIN LEGEND Network Manager's Guide for
instructions. At this point the CTI link should be operational.

Link Reinstatement

The considerations and hardware requirements for a link reinstatement are the
same as those for a new installation since this procedure is used only after a
link shutdown.
A summary of the installation procedure for a link reinstatement is provided
below:
Plug in the CTI link, if unplugged.

As a general rule, do not plug in a CTI link unless the port is programmed
as a CTI link port. Also, do not plug a telephone into a CTI link port. The
other end of this wire is plugged into the ISDN link interface card installed
in Step 3 of the "New Installation" procedure.
Resume CTI link traffic.

Refer to the MERLIN LEGEND Network Manager's Guide for
instructions.
Resume MERLIN LEGEND alarming for the CTI link.

Refer to the MERLIN LEGEND Network Manager's Guide for
instructions.
Issue 1
June 1997
Page 8-29