Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 1418

Setting the Seed Switch in Cisco SAN-OS Releases 3.1(1) to 3.2(1)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure A-1
Set FM Server to the IP address where you installed Fabric Manager Server, or set it to localhost if you
Step 2
installed Fabric Manager Server on your local workstation.
If you forget your password, you can run one of the following scripts:
Both of these scripts are available as UNIX .sh files.
Enter the Fabric Manager Server user name and password.
Step 3
Check the Use SNMP Proxy check box if you want Fabric Manager Client to communicate with Fabric
Step 4
Manager Server through a TCP-based proxy server.
Click Login. After you successfully log in to Fabric Manager Server, you can set the seed switch and
Step 5
open the fabrics that you are entitled to access.
You see the Discover New Fabric dialog box shown in
Figure A-2
Set the fabric seed switch to the Cisco MDS 9000 Family switch that you want Fabric Manager to use.
Step 6
Step 7 Enter the user name and password for the switch.
Step 8 Choose the Auth-Privacy option MD5-DES (default) when you log in.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
A-2
Fabric Manager Server Login Dialog Box
bin\webUserAdd.bat admin password adds a user name and password to the Fabric Manager
–
Server database.
bin\DBReset.bat resets the database back to the initial state and removes any discovered
–
fabrics.
Discover New Fabric Dialog Box
Appendix A Launching Fabric Manager in Cisco SAN-OS Releases Prior to 3.2(1)
Figure A-2.
OL-17256-03, Cisco MDS NX-OS Release 4.x