Configuring The Time Zone - Cisco 4700M Administration Manual

Chapter 1 Setting Up the ACE
Restriction
If you previously configured NTP on an ACE, the ACE prevents you from using the clock set command
to set the time and the date and displays an error message. To manually set the ACE system clock,
remove the NTP peer and NTP server from the configuration before setting the clock on an ACE. See
the
Detailed Steps
Command
hh:mm:ss DD MONTH YYYY
Step 1
clock set
Example:
host1/Admin# clock set 01:38:30 7 August
2009
Fri Aug 7 01:38:30 PST 2009
Step 2
show clock
Example:
host1/Admin# show clock
Fri Aug 7 01:38:30 PST 2009

Configuring the Time Zone

This section describes how to set the time zone of the ACE. The ACE keeps time internally in Universal
Time Coordinated (UTC) offset.
OL-20823-01
"Synchronizing the ACE with an NTP Server"
Cisco 4700 Series Application Control Engine Appliance Administration Guide
section for more information.
Purpose
Sets the time and the date for an ACE. When you enter this
command, the ACE displays the current configured date and
time.
The arguments are:
hh:mm:ss—Current time to which the ACE clock is being
•
reset. Specify two digits for the hours, minutes, and seconds.
DD MONTH YYYY—Current date to which the ACE clock is
•
being reset. Specify one or two digits for the day, the full
name of the month, and four digits for the year. The
following month names are recognized: January, February,
March, April, May, June, July, August, September, October,
November, and December.
(Optional) Displays the current clock settings.
Setting Up the ACE
1-17