References - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual

Software for e series broadband services routers ip, ipv6, and igp configuration guide
Table of Contents

Advertisement

References

Copyright © 2010, Juniper Networks, Inc.
See ERX Module Guide, Appendix A, Module Protocol Support for information about the
modules that support IS-IS.
For information about modules that support IS-IS on the E120 and E320 Broadband
Services Routers:
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support IS-IS.
For more information about the IS-IS protocol, consult the following resources:
JunosE Release Notes, Appendix A, System Maximums—See the Release Notes
corresponding to your software release for information about maximum values.
ISO International Standard 8473-1:1993—Information technology – Protocol for
providing the connectionless-mode network service
ISO International Standard 9542:1988 (E)—Information processing systems –
Telecommunications and information exchange between systems – End
System-to-Intermediate System Routing Exchange Protocol for use in conjunction
with the protocol for providing the connectionless-mode network service (ISO 8473)
ISO/IEC 10589:1992—Information technology – Telecommunications and information
exchange between systems – Intermediate System-to-Intermediate System
Intra-Domain Routing Exchange Protocol for use in conjunction with the protocol for
providing the connectionless-mode network service (ISO 8473)
Extended Ethernet Frame Size Support—draft-ietf-isis-ext-eth-01.txt (November 2001
expiration)
Management Information Base for IS-IS—draft-ietf-isis-wg-mib-16.txt (January 2005
expiration)
Point-to-point operation over LAN in link-state routing
protocols—draft-ietf-isis-igp-p2p-over-lan-05.txt (January 2005 expiration)
RFC 1195—Use of OSI IS-IS for Routing in TCP/IP and Dual Environments (December
1990)
RFC 2763—Dynamic Hostname Exchange Mechanism for IS-IS (February 2000)
RFC 2966—Domain-wide Prefix Distribution with Two-Level IS-IS (October 2000)
RFC 2973—IS-IS Mesh Groups (October 2000)
RFC 3277—Intermediate System to Intermediate System (IS-IS) Transient Blackhole
Avoidance (April 2002)
RFC 3373—Three-Way Handshake for Intermediate System to Intermediate System
(IS-IS) Point-to-Point Adjacencies (September 2002)
Chapter 6: Configuring IS-IS
331

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents