Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 254

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
230
Triggered Updates = enabled
Purge Routes on Interface Down Event
Send More Specific Routes
Debounce Time = 10
Default-Information originate : disabled
route-map : none
Summary Address:
Network netmask
Neighbor
No Configured Neighbors
*** Interface Configuration Data***
loopback1
Send version = def
Receive version = def
Authentication mode = none
Default metric = default
Passive Interface = No
Access-list applied to outgoing route = none
Access-list applied to incoming route = none
Route-map applied to outgoing route = none
Copy configuration to dynamic interfaces
*** Address Configuration Data ***
Unnumbered, Rip is up, ATM2/1.18
Dynamic creation and inherits configuration from loopback1
Received bad packet = 0
Received bad routes = 0
Triggered updates sent = 0
Received updates = 3
1.1.1.1, Rip is up, loopback1
Send version = def
Receive version = def
Authentication mode = none
Default metric = default
Passive Interface = No
Access-list applied to outgoing route = none
Access-list applied to incoming route = none
Route-map applied to outgoing route = none
Received bad packet = 0
Received bad routes = 0
Triggered updates sent = 0
Received updates = 0
Example 3—Interface configuration data excerpt showing BFD information.
host1#show ip rip ifconfig
*** Interface Configuration Data***
FastEthernet1/0
Send version = def
Receive version = def
Authentication mode = none
Default metric = default
BFD minimum receive interval(msec) =
BFD minimum transmit interval(msec)= 500
BFD multiplier = 2
Passive Interface = No
Access-list applied to outgoing route = none
= enabled
= enabled
None
400
Copyright © 2010, Juniper Networks, Inc.