Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
ipv6 nd suppress-ra
ipv6 nd suppress-ra-source-link-layer
Configuring Proxy Neighbor Advertisements
ipv6 nd proxy
196
See ipv6 nd reachable-time
Use to suppress IPv6 router advertisement transmissions on a local area network
(Ethernet) interface.
Example
host1(config-if)#ipv6 nd suppress-ra
Use the no version of this command to reenable the sending of IPv6 router
advertisement transmissions on the LAN (Ethernet) interface
See ipv6 nd suppress-ra
Use to suppress IPv6 router advertisement transmissions on a local area network
(Ethernet) interface.
Example
host1(config-if)#ipv6 nd suppress-ra-source-link-layer
Use the no version of this command to reenable the sending of IPv6 router
advertisement transmissions on the LAN (Ethernet) interface.
See ipv6 nd suppress-ra-source-link-layer
Much like proxy ARP, proxy Neighbor Discovery is a means by which one interface responds
to a Neighbor Discovery query on behalf of another interface.
To configure proxy Neighbor Discovery:
Access an IPv6 interface.
1.
host1(config)#interface fastEthernet 0/0
host1(config-if)#
Enable Neighbor Discovery on the current interface.
2.
host1(config)#ipv6 nd
NOTE: This command is redundant when configuring Neighbor Discovery
over Ethernet, because neighbor solicitations and advertisements are
automatically sent on Ethernet interfaces.
Enable IPv6 neighbor proxy.
3.
host1(config-if)#ipv6 nd proxy
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
