Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
Adding a Description
ipv6 description
IPv6 TCP Configuration
138
Use to specify the layer 2 interface used by a shared IPv6 interface. The command fails
if the layer 2 interface does not yet exist. The command is not supported (that is, it
fails) if you use an RSVP tunnel (for example, tunnel mpls:1) to identify the layer 2
interface.
After creating the shared IPv6 interface, you can configure it as you do any other IPv6
interface.
The shared interface is operationally up when the layer 2 interface is operationally up.
You can create operational shared IPv6 interfaces in the absence of a primary IPv6
interface.
Example
host1(config-if)#ipv6 share-interface atm 5/3.101
Use the no version to remove the association between the layer 2 interface and the
shared IPv6 interface. You can delete shared and primary IPv6 interfaces independently.
See ipv6 share-interface
The router enables you to add a text description or an alias to an IPv6 interface or
subinterface. Adding a description helps you identify the interface and keep track of
interface connections.
Use to assign a text description or an alias to an IPv6 interface or subinterface.
The description or alias can be a maximum of 256 characters.
Use the show ipv6 interface command to display the text description.
Example 1
host1(config-if)#ipv6 description boston01 ipv6 interface
Example 2
host1(config-subif)#ipv6 description dallas05 ipv6 subinterface
Use the no version to remove the text description or alias.
See ipv6 description
IPv6 supports TCP configuration. You use the same commands to configure TCP on IPv6
as you do to configure TCP on IPv4.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
