Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 235

disable-dynamic-redistribute
distance
distribute-list
interface-event-disable
Copyright © 2010, Juniper Networks, Inc.
Use to disable RIP processing.
Example
host1(config-router)#disable
Use the no version to enable RIP processing.
See disable
Use to halt the dynamic redistribution of routes that are initiated by changes to a route
map.
Dynamic redistribution is enabled by default.
Example
host1(config-router)#disable-dynamic-redistribute
Use the no version to reenable dynamic redistribution.
See disable-dynamic-redistribute
Use to set the administrative distances for routes.
Example
host1(config-router)#distance 150
Use the no version to restore the default value, 120.
See distance
Use to apply a specific access list to incoming or outgoing RIP route updates.
An IP access list acts as a filter. Refer to access-list in the JunosE Command Reference
Guide for more information.
Example
host1(config-router)#distribute-list 5 incoming
Use the no version to stop application of the distribute list.
See distribute-list
Use to configure RIP to purge the routing table for interfaces that were brought down
by some event.
Example
host1(config-router)#interface-event-disable
Chapter 4: Configuring RIP
211