Table of Contents
Advertisement
ipv6 nd
ipv6 mtu
Copyright © 2010, Juniper Networks, Inc.
Use the no version of this command to remove an IPv6 address.
See ipv6 address
Use to enable the IPv6 Neighbor Discovery process on an interface.
You can include the following commands in IPv6 profiles to configure Neighbor
Discovery route advertisement characteristics. For additional information, see "Using
IPv6 Profiles and RADIUS to Configure Neighbor Discovery Route Advertisements" on
page 192 in "Configuring Neighbor Discovery" on page 189.
Command
ipv6 nd
ipv6 nd managed-config-flag
ipv6 nd other-config-flag
ipv6 nd prefix-advertisement
ipv6 nd ra-interval
ipv6 nd ra-lifetime
ipv6 nd reachable-time
ipv6 nd suppress-ra
Example
host1(config)#profile ProfileIpv6South22
host1(config-profile)#ipv6 nd
Use the no version to disable the Neighbor Discovery process for the profile.
See ipv6 nd
Use to set the MTU size of IPv6 packets sent on an interface.
The range is 128–10240.
Example
host1(config-if)#ipv6 mtu 1000
Use the no version to restore the default MTU size.
See ipv6 mtu
Description
Enables Neighbor Discovery on an interface
Sets the "managed address configuration" flag in IPv6 router
advertisements
Sets the "other stateful configuration" flag in IPv6 router
advertisements
Specifies IPv6 prefix included in IPv6 router advertisements
Configures the interval between IPv6 router advertisements
Configures the router advertisement lifetime
Configures the amount of time the router can reach an IPv6
node after a reachability confirmation event occurs
Disables router advertisement transmissions
Chapter 2: Configuring IPv6
131
Advertisement
Table of Contents
