Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
Platform Considerations
References
Before You Configure Neighbor Discovery
190
Address resolution—How a node uses only a destination IPv6 address to determine a
link-layer address for destinations on an attached link.
Next-hop determination—The algorithm that a node uses for mapping an IPv6
destination address into a neighbor IPv6 address (either the next router hop or the
destination itself) to which it plans to send traffic for the destination.
Neighbor unreachability detection—How a node determines that it can no longer reach
a neighbor.
Duplicate address detection—How a node determines whether an address is already
in use by another node.
For information about modules that support Neighbor Discovery on the ERX7xx models,
ERX14xx models, and the ERX310 Broadband Services Routers:
See ERX Module Guide, Table 1, Module Combinations for detailed module specifications.
See ERX Module Guide, Appendix A, Module Protocol Support for information about the
modules that support Neighbor Discovery.
For information about modules that support Neighbor Discovery on the E120 and E320
Broadband Services Routers:
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support Neighbor Discovery.
For more information about Neighbor Discovery, consult the following resource:
RFC 2461—Neighbor Discovery for IP Version 6 (IPv6) (December 1998)
You can access these and other Internet RFCs and drafts at the following URL:
http://www.ietf.org
Before you configure Neighbor Discovery, you must configure IPv6. For information about
configuring IPv6, see "Configuring IPv6" on page 121.
Configuring Ethernet interfaces to function with IPv6 requires Neighbor Discovery
configuration for the interface.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
