Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 132

Software for e series broadband services routers ip, ipv6, and igp configuration guide
Table of Contents

Advertisement

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
108
Source address/port – local port—Shows the 32 most recent TCP connection
attempts that were rejected, including the remote node's IP address and port, the
local port for the connection attempt, and the number of identical attempts that
have been received on that port in a row. The reason for rejection is not given. This
information may be useful in tracking down DoS attacks.
# connection-reqs rejected—Total number of connection attempts that have been
rejected
# connection-reqs pending—Current number of connection attempts that are
pending, awaiting additional data from the peer
# sonewconn calls that fail—Number of calls to sonewconn that have failed. This
statistic often indicates that either a socket connection limit has been reached or
that there was no memory to hold the socket data structures.
TCP Session Statistics
Local addr—Local address of the TCP connection
Local port—Local port number of the TCP connection
Remote addr—Remote address of the TCP connection
Remote port—Remote port number of the TCP connection
State—Current state of the TCP connection
Authentication—Authentication status of the TCP connection
TCP Session Statistics Sent:
total pkts—Total number of packets sent on the TCP connection
data pkts—Number of data packets sent on the TCP connection
bytes—Number of bytes sent on the TCP connection
retransmitted pkts—Number of packets retransmitted on the TCP connection
retransmitted bytes—Number of bytes retransmitted on the TCP connection
TCP Session Statistics Rcvd:
total pkts—Total number of packets received on the TCP connection
in-sequence pkts—Number of packets received in sequence on the TCP connection
bytes—Number of bytes received on the TCP connection
chksum err pkts—Number of checksum error packets received on the TCP
connection
bad offset pkts—Number of bad offset packets received on the TCP connection
short pkts—Number of short packets received on the TCP connection
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents