Monitoring Ip; System Event Logs - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
show rtr operational-state

Monitoring IP

System Event Logs

76
2
2
rtrIndex hop operationsSent operationsRcvd
-------- --- -------------- --------------
2 1
2 2
See show rtr hops
Use to display RTR operational information.
Field descriptions
rtrIndex—Index number of the RTR probe
type—Type of RTR probe: echo, pathEcho
entryStatus—If the entry was created via the SNMP DISMAN MIB, the row may be
partially constructed; if that is the case, the CLI displays notReady as the entry's
status
adminStatus—Derived from the rtr schedule start-time command; if the option is
now, the status is enabled; if the option is pending, the status is disabled
operStatus—Enabled only if entryStatus and adminStatus are enabled and the test
is running; operStatus remains enabled if the test finishes and restart time is not 0
Example
host1#show rtr operational-state
rtrIndex type
---------- --------
1 echo
2 pathEcho
See show rtr operational-state
This section explains how to set a statistics baseline and use the show commands to
view your IP configuration and monitor IP interfaces and statistics.
To troubleshoot and monitor IP, use the following system event logs:
ipAccessList—IP access list matching
ipEngine—IP chassis manager
ipGeneral— IP general information
ipIfCreator—IP interface creator events
1 192.168.1.1 1
2 10.2.0.3 0
36985 36838
30717 21494
entryStatus adminStatus
----------- ----------- ----------
active enabled
active enabled
276 1 955363
1109 2 10094451
lastGoodResponse
------------
09/18/2000 20:20
09/18/2000 20:20
operStatus
enabled
enabled
Copyright © 2010, Juniper Networks, Inc.