Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
ip route-type
ipv6 route-type
mpls traffic-eng multicast-intact
OSPF and BGP/MPLS VPNs
284
in the unicast view of the routing table, whereas routes available for multicast RPF checks
appear in the multicast view of the routing table.
To enable a multicast protocol and MPLS traffic engineering (TE) to interoperate on a
router running OSPF, use the mpls traffic-eng multicast-intact command.
Use to specify whether OSPF routes are available only for unicast forwarding, only for
multicast RPF checks, or for both.
Use the show ip route or show ipv6 route command to view the routes available for
unicast forwarding.
Use the show ip rpf-routes or show ipv6 rpf-routes command to view the routes
available for multicast RPF checks.
By default, OSPF routes are available for both unicast forwarding and multicast RPF
checks.
Example 1
host1(config)#router ospf
host1(config-router)#ip route-type unicast
Example 2
host1(config)#router ospf
host1((config-router)#)#ipv6 route-type unicast
Use the no version to restore the default value, both.
See ip route-type
See ipv6 route-type
Use to enable a multicast protocol and MPLS traffic engineering (TE) to interoperate
on a router running OSPF.
Example
host1(config-router)#mpls traffic-eng multicast-intact
Use the no version to disable interoperability between a multicast protocol and
MPLS-TE when running on an OSPF router.
See mpls traffic-eng multicast-intact
Some network topologies use OSPF as the routing protocol between CE and PE routers
in BGP/MPLS VPNs. See JunosE BGP and MPLS Configuration Guide, for information about
configuring OSPF for this purpose.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
