Table of Contents
Advertisement
JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
default-information originate
disable-dynamic-redistribute
distance
ip ospf shutdown
ipv6 ospf shutdown
276
Use to generate a default route into an OSPF routing domain.
When you use this command to redistribute routes into an OSPF routing domain, the
router automatically becomes an AS boundary router.
An AS boundary router, however, does not, by default, generate a default route into
the OSPF routing domain. The software must have a default route before it generates
one, except when you have specified the always keyword.
You can specify a metric for the route or specify that the route be OSPF external type
1 or 2.
Example
host1(config)#router ospf 1
host1(config-router)#default-information originate route-map 5
Use the no version to disable this feature.
See default-information originate
Use to halt the dynamic redistribution of routes that are initiated by changes to a route
map.
Dynamic redistribution is enabled by default.
Example
host1(config-router)#disable-dynamic-redistribute
Use the no version to reenable dynamic redistribution.
See disable-dynamic-redistribute
Use to configure the administrative distance for OSPF routes.
Example
host1(config-router)#distance ospf external 60
Default settings:
Intra-area routes—110
Interarea routes—112
External routes—114
Use the no version to restore the default values.
See distance
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
