Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 120

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
show ip redistribute
show ip route
96
Use to display configured route redistribution policy.
Field descriptions
To—Protocol that routes are distributed into
From—Protocol that routes are distributed from
status—Redistribution status
route map number—Number of the route map
Example
host1#show ip redistribute
To ospf, From static is enabled with route map 4
To ospf, From connected is enabled with route map 3
See show ip redistribute
Use to display the current state of the routing table, including routes not used for
forwarding.
You can display all routes, a specific route, best route to a resolved domain name, all
routes beginning with a specified address, routes for a particular protocol (BGP, IS-IS,
OSPF, or RIP), locally connected routes, internal control routes, static routes, or
summary counters for the routing table.
Field descriptions
Protocol/Route type codes—Protocol and route type codes for the table that follows
Prefix—IP address prefix of network destination
Length—Network mask length for prefix
Next Hop—IP address of the next hop to the route, whether it is a local interface or
another router
Dist—Administrative distance for the route; see Table 5 on page 27
Met—Number of hops
Intf—Interface type and interface specifier
Example 1
host1#show ip route
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
L- MPLS label, V- VR/VRF, *- indirect next-hop
Copyright © 2010, Juniper Networks, Inc.