Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual page 299

clear ip ospf neighbor
clear ip ospf redistribution
clear ipv6 ospf redistribution
Copyright © 2010, Juniper Networks, Inc.
host1#clear ip ospf database
There is no no version.
Use to clear an IP OSPF neighbor by specifying the IP address.
NOTE: When OSPF is configured and running over an NBMA network, do not
issue the clear ip ospf neighbor command simultaneously on both ends of
the OSPF link. Doing so brings the OSPF link down completely. In this event,
you must do one of the following on both sides of the link to bring the link
back up:
Reconfigure the OSPF neighbors on the NBMA interface with the neighbor
command.
Issue the clear ip ospf database command to clear and reset the OSPF
adjacencies.
Issue the shutdown command followed by the no shutdown command on
the interface.
Example
host1#clear ip ospf neighbor neighborAddress
There is no no version.
See clear ip ospf neighbor
Use to clear and readvertise all of the routes that have been previously redistributed
into OSPF.
CAUTION: Using this command purges all external LSAs and reoriginates.
Example 1
host1#clear ip ospf redistribution
Example 2
host1#clear ipv6 ospf redistribution
There is no no version.
See clear ip ospf redistribution
See clear ipv6 ospf redistribution
Chapter 5: Configuring OSPF
275